View Full Version : The UI is Too Big

1st Dec 2010, 1:15 AM
I have just installed "Create a Pattern" on to my laptop (I do not own a desktop) however the User Interface is too big and the bottom of the screen (with all the controls - edit,save,stencils etc) are below my tool bar.

I cannot move the screen as it does not give me the option of a scroll bar.

I have tried to hide my toolbar but it does not help. Can anyone help me as I cannot use the tool if I cannot access these controls?


1st Dec 2010, 1:45 PM
Sounds like maybe your screen resolution is too low- try increasing it to see if that works.

2nd Dec 2010, 4:39 AM
Thank you very much simsample, I'm afraid I'm technically challenged.... your advice did the trick.

10th Jan 2011, 10:36 PM
I have the same problem, but I've set my screen resolution to the highest it can go (1366 x 768). CAP is the only program that does this that I can't change. I tried setting it to windowed mode with constraints on the proportions but it completely ignored them and I'm at a loss for what to do. I can't access most of the controls.

20th May 2011, 11:59 PM
I have the same problem. My screen thingy is at it's highest too.