I'm playing with the rabbit holes and I've made a new mesh and new routing slots,
based off the rig file of the original.
For testing purposes, i'm using 1 set of 4 slots, 2 for entering and 2 for exiting.
They start 3 meters from the object and end 1 meter from it
and are barely inside it's footprint.

When i try to get a sim to use it, the sim will stand at the starting point and then get reset (jumps back and the action is canceled)
indicating an error has occurred.
Sometime the sim will successfully enter the building, but the error occures when they appear at the exit point.

Help figuring out the cause of the error is greatly appreciated